NinjaPrompter

Speaking speed test

Updated · Free, runs in your browser

Find your speaking speed in words per minute. Tap Start, read the passage below aloud at the pace you'd use for a talk or a video, then tap Stop. The page times your taps; there's no microphone.

The result is an estimate of how fast you read this passage. A second try is often steadier.

Read this aloud

Every town has a place where people stop for a minute on their way to somewhere else. In ours, it is a small bakery on the corner, with a green door and a bell that rings a little too loudly. The owner opens before the sun comes up, and by the time the first bus goes by, the windows are fogged and the shelves are full.

Most mornings, the same faces come in. A nurse buys two rolls after a long night. A boy counts his coins for a cookie and is always one short. An older man orders the same thing, then asks what is new, as if the answer might change his mind. It never does. The coffee is fine, but that is not why they come. Nobody hurries here, even when they are late. They wait their turn, say good morning, and leave a little warmer than they came in.

Your speaking speed

0:00

Tap Start, read every word aloud, then tap Stop.

Times your taps only. No microphone, and nothing is recorded or saved.

How fast do people talk?

Microsoft recommends 100 to 165 words per minute for presenters, the range it says most audiences it tested find easiest to follow (Microsoft Support). About 150 is a common figure to plan a script with. Public speaking pace gives the figures for other kinds of speaking, like reading aloud and audiobook narration.

Reading a script aloud can run faster than talking off the cuff: a review of reading-rate studies puts the average oral reading rate at about 183 words per minute (Brysbaert, 2019), above the top of Microsoft's range. So this test shows the pace a script or a teleprompter needs, not how you talk in conversation. The speech length calculator takes a pace from 100 to 180 words per minute. A result outside that range is set to the nearest end.

How it's measured

  • The page divides the words in the passage by the time between your two taps.
  • A late or early tap shifts the result by a few words per minute, so read the whole passage and tap as you finish.
  • Pauses you take while reading count as part of your pace. To plan marked pauses, the calculator adds them separately.

Use your pace

The link under your result opens the speech length calculator with that pace already set. Paste your script there to see how long it takes to read aloud.

To try your pace on a ready-made script, read one of the sample teleprompter scripts.

Two other pages put pace in a table. See how many words are in a speech of a given length, or how long it takes to read words aloud. Pick the column closest to your pace.

To match a teleprompter to your pace, see how to set the scroll speed to your pace.

To read your script from your iPhone, NinjaPrompter takes the pause and pace marks the calculator counts. In Performance mode, it holds your pauses and changes pace at [slower] and [faster]. Performance mode is part of the 7-day trial and the subscription.