NinjaPrompter

How to read a teleprompter naturally

By , Founder ·

You read a teleprompter naturally when your eyes barely move, and that depends mostly on where the text sits and how wide each line is. Put the text close to the lens, keep the lines short, and make the letters large enough to read from where you sit. Then read a phrase ahead and say each thought to the camera. These tips work with any teleprompter:

  • Put the teleprompter right next to the lens, at eye level, and sit back far enough to read without leaning in.
  • Use a narrow width and large text, so your eyes make small moves.
  • Keep your eyes a phrase ahead of your voice.
  • Keep your head still, blink as you normally do, and let your face and hands move as they would in conversation.
  • Set the speed a little below your pace, and know how to find your place again.

NinjaPrompter, a teleprompter for iPhone, has settings for the text size, the column width, and the speed, and the sections below name them. Writing pauses and pace changes into the script is a separate step, and how to read a script without sounding like you're reading covers it, along with when to look at the camera, where to put the reading guide, and how to set the scroll speed by ear.

Why your eyes move when you read a teleprompter

Your eyes travel from the start of each line to its end, and the wider the line, the more noticeable your eye movement looks on camera. The angle your eyes turn is roughly the width of the line divided by your distance from it, so a narrower line or a greater distance makes the movement smaller. The camera also sees where your eyes rest. When the text sits a few centimeters away from the lens, your eyes rest just off the lens the whole time.

Here's a rough example. Text on a phone held upright is about 6 cm wide, and if you read it from 50 cm away, your eyes turn about 7 degrees across each line. A full-width line on a laptop screen, about 25 cm, makes them turn about 28 degrees from the same distance, which is four times as far. If you move back to 1 m from the phone, the 6 cm line makes them turn about 3.5 degrees. Sitting farther back also brings your gaze closer to the lens, because the same gap between the text and the lens makes a smaller angle from farther away. So in any setup, sit as far back as you comfortably can, keep the text column width narrow, and raise the text size until you can still read it from there.

Set up a phone as a teleprompter so the text sits at the lens

Put the phone right next to the lens, at eye level, and sit far enough back that you can read a whole line without leaning in or turning your head. A phone suits this well, because its screen is narrow, so a line on it is only a few centimeters wide. With teleprompter glass, the script sits in front of the lens itself, so you look into the lens as you read. How a teleprompter works explains why, and the DIY iPhone teleprompter guide shows how to build a rig with glass for your phone. How to use your phone as a teleprompter covers where the phone goes with each kind of camera.

Once the phone is in place, here are some tips on the settings:

  • Start from where you'll sit. Raise Font size in Reading settings until you can read a whole line comfortably from there. A larger Font size also puts fewer words on each line.
  • Narrow the column if your eyes still travel. On a phone held upright, the lines are already short. If your eyes still move from side to side, lower Column width, in the same section as Font size.
  • Put one phrase on each line. When each line of the script holds one phrase, you can take it in with one look. Breaking the text where you breathe shows where to put the line breaks.
  • Set the orientation before you press Play. The prompter keeps its orientation while the script plays, so put the phone where it will sit and turn it to portrait or landscape first.

To check all of this from where you'll sit, read the teleprompter test script, which has long and short lines to try.

Read the next line while speaking the current (instead of chasing the text)

Keep your eyes about one phrase ahead of the words you're reading, so you say the phrase you've just read while your eyes move on to the next one. If you read each word just as you say it, your eyes have to chase the text, and the camera picks up each of those small movements. With a narrow column, you can take in most of a line at a glance, so your eyes mostly move down the column instead of across it.

Reading ahead feels odd at first, and it gets easier after a few practice runs. You don't have to hide every glance at the text, either. People look away briefly when they talk to someone, so an occasional glance looks natural.

Keep your head still and your face moving

Keep your head still and let only your eyes make the small moves, while your face and hands do what they normally do in conversation. If your head turns or nods along with each line, the viewer can tell you're following text. It's also common to stop blinking while you concentrate, which is another problem because a fixed stare looks tense on camera, so blink as you normally would.

Let your eyebrows and your smile follow what you're saying, and use your hands if you normally do and they're in the shot. When the viewer sees you talking naturally, they pay less attention to where your eyes are.

Set the speed yourself when nobody operates the teleprompter

Without an operator, nobody slows the text down when you need a moment, so set Scroll speed a little below the pace you speak. You can change it during the take on the slider below the Play button, and the new speed applies right away, without pausing the script. Raise it when you find yourself waiting for the text, and lower it when you're chasing it.

An operator or a foot pedal can also stop the text for you. On your own, you can plan those stops in the script. In Performance mode, the prompter holds at the pause marks you type, such as //, and changes speed at [slower] and [faster]. A line you tend to trip on is a good place for [slower]. Performance mode is off by default, and it's part of the 7-day trial and the subscription. Showing the marks is free. How to use pauses in a speech shows where to put the pause marks.

For a stop you didn't plan, press Pause.

Find your place again after you lose it

When you lose your place, stop speaking, find the start of the sentence you were on, and say it again from there. If you're recording, the pause leaves a clean place to cut when you edit.

In NinjaPrompter, drag the text until the start of that sentence sits at the reading guide, then press Resume. Dragging pauses the script, and Resume carries on from wherever the text now sits. It starts at once, with no countdown, so be ready to speak as soon as you press it. If you can't see the guide, turn on Show reading guide in Reading settings.

To jump further, use Previous paragraph and Next paragraph (the rewind and fast-forward icons below Play). Each one moves the text by a paragraph, which is the text up to the next line break, and leaves the script paused, so press Resume to carry on. To start over, tap Restart (the skip-to-start icon above Play, on the right). Unless you're already at the beginning, it asks "Restart from the beginning?" first, and after a restart, Play runs your countdown again.

Try the whole routine once before you record, so you know where your hand goes.

Review a practice take with the sound off

Record a practice take, then watch it with the sound off. Without your voice to listen to, you notice what the viewer sees, such as your eyes, your head, and your face. NinjaPrompter doesn't record, so film the take with the camera you'll use, with the phone set up as it will be on the day.

If your eyes travel from side to side, sit farther back, raise Font size, or lower Column width. If your face looks stiff, or your head turns with the lines, do another take and let your expression and your hands follow what you're saying.